Moonroof (Except RS) To open or close the moonroof, push and hold the switch. Release the switch when the moonroof reaches the desired position.
Do not hold the switch on after the moonroof has fully opened or
closed, or you may damage the moonroof motor.
Do not allow any part of your body to extend through the moonroof while the vehicle is in motion. In the event of a collision or sudden application of the brakes, severe personal
injury could result.
To avoid the possibility of injury while closing the moonroof, never allow any part of your body to extend through the opening.
CAUTION:
Operating the moonroof in severe cold or when it is covered with snow or ice may cause damage to the moonroof.
Sunshade
As well as the moonroof, there is a sliding sunshade which you can adjust to let in light with the roof closed, or to block out light entirely. The sunshade automatically opens as you open the moonroof.
(cont'd)
POP-UP WIND
DEFLECTOR Close
Open
SUNSHADE
Moonroof (cont'd)
If the Moonroof Won't Close
The moonroof can be closed manually, if the control switch will not close it.
1. Remove the round plug near the rear center of the headliner.
2. Insert the moonroof wrench (from the tool kit) into the socket.
3.Turn the wrench until the moonroof seats in the closed position.
4. Replace the plug.
Maintenance
Periodically pour a little water down the drain holes to make sure they are not plugged. If they are free, water should drop on the ground behind each front wheel.
CAUTION:
Do not put weight on the moonroof or force it open or closed, you may damage the mechanism.
DRAIN HOLE
Remove plug
SOCKET
Stereo Sound System (Except US: RS)
(Canada: RS)
(LS)
(GS/GSR)
ON/OFF Switch
Turn the switch clockwise to turn the unit on; turn it counterclock-wise to turn the unit off.
NOTE:
(Except Canada: RS)
The antenna will rise or retract automatically when the unit is turned on or off. It will also retract automatically if the ignition is
switched off.
Volume Control
Turn the ON/OFF switch clockwise to increase volume and counter-clockwise to decrease volume.
(cont'd)
Tone Control
Bass Control
Treble Control
Treble Control
Bass Control
Stereo Sound System (cont'd)
Balance Control
Balances sound between left and right speakers.(Except Canada: RS)
To use the control, push on the knob to get it to pop out, adjust the balance to your liking and push the knob back in when you are done.
NOTE:
(Except Canada: RS)
When the headlights are on, the radio panel illumination is on, even if the radio is turned off.
The panel lighting can be turned off by first pushing the Balance Control knob to its out position and then pulling it out slightly
further.
Fader Control
Balances sound between front and rear speakers.(Except Canada: RS)
To use the control, push on the knob to get it to pop out, adjust the sound to your liking and push the knob back in when you are done.
(Canada: RS)
(LS)
Frequency Display Frequency Display (GS/GSR)
Frequency Display
Radio Operation
AM/FM Band Selector
Push to select AM or FM band. The corresponding band indicator will light.
Manual Tuning
(US: LS, Canada: RS/LS)
Push the button to tune to a lower frequency station.
Push the button to tune to a higher frequency station.
(GS/GSR)
Push the TUNE/SEEK switch up to change to a higher frequency, and down to change to a lower frequency.
To change the frequency up or down a single increment, push and release the TUNE/SEEK switch.
NOTE:
(US: LS, Canada: RS/LS)
If you hold either button for more than half a second, the tuning frequency will count up or down rapidly.
东风日产(GS/GSR)
To go to a frequency that is farther away, push the switch and hold it. You will hear a beep and the frequency display will begin to count rapidly.
Seek Tuning
(Canada: RS)
Each time you push this button, the tuner will automatically seek the next higher frequency station.
(LS)
Each time you push this button up or down, the tuner will automatically seek the next higher or lower frequency station.
(GS/GSR)
Depending on which way you push the TUNE/SEEK switch, the system searches up or down from the current frequency. Push the switch until you hear a beep, then release it. The system searches until it finds a station with a strong signal, then stops.
(cont'd)
发布评论