遥控钥匙调整开锁方式：同时按遥控上的开锁键和锁车键，大概3秒看到灯闪两下就OK！开锁方式可以重复设换，方法一样。
广汽长丰汽车福克斯调出自动落锁功能的英文版-翻译
简单地翻译了一下，供大家参考，我准备这两天验证一下！！！！！！！
The enable/disable mode is entered when the following series of steps is performed.
Install Time: Difficulty Level:
5 Minutes 1
Directions:
Step 1雅骏
Confirm that the perimeter alarm is disarmed.
确认车辆安全停放
Step 2
Close all doors.
关闭所有车门
Step 3
Confirm that the ignition switch is in the OFF position.
Note: Steps 4 through 8 must be performed within 30 seconds.
确认车辆点火开关处于关闭状态
注意：第四步骤到第八步骤必须在30秒内完成
Step 4
Turn the ignition switch from OFF to RUN.
将点火开关从关闭到打开状态（开关从I到II状态，不要着车）
Step 5
Press the power door lock UNLOCK button three times.
将车门锁从开到关连续按动3次（关-开-关-开-关-开）
Step 6
Turn the ignition switch from RUN to OFF.
将车辆点火开关从打开到关闭状态（从II到I）
rx5maxStep 7
起亚k2三厢怎么样Press the power door lock UNLOCK button three times.
将车门锁从开到关连续按动3次（关-开-关-开-关-开）
Step 8申蓉汽车
Turn the ignition switch from OFF to RUN.
将车辆点火开关从关闭到打开状态（从I到II）
Step 9
Verify that the RAP module chirps the horn. This indicates that the RAP module is now in the enable/disable mode and ready to accept program changes.
长城汽车公司Step 10
Press the power door lock UNLOCK button one time to command the RAP module to toggle the autolock/relock feature ON or OFF.
将车门锁从关到开一次（关-开），以触发行车电脑模块的自动锁生效或取消。
Step 11
Press the power door lock LOCK button once to enter the command.
将车门锁从关到开一次（关-开），（RAP）执行指令。
Step 12
Verify that the vehicle horn chirps one time to signal the RAP module confirmation of the command. There should only be one chirp indicating that the autolock/relock feature has been disabled. If one chirp is heard, followed by a longer honk, the autolock/relock feature has just been enabled. Return to step 10.
这时会听到一声短鸣声，说明行车电脑模块指令已经执行。如果听到一声短鸣声，说明自动锁功能被取消，如果听到一声长鸣声，说明自动锁功能启动。重新执行第十步骤。
Step 13
Turn the ignition switch to the OFF position to exit the enable/disable mode.
将车辆点火开关转到关闭状态，退出编辑模式。
Step 14
Verify that the RAP module chirps the horn once to indicate that a feature has been changed.
会再听到一声短鸣声，表示设置成功。
发布评论